FAQs:
Unable start-up: Check whether the main power enter; check the circuit of electric box whether connected; check if there is broken wires in contact with an induction loop; check stop spin button is in static status; the wear belt does not work normally.
Difficult: to start-up: Check whether there is a belt worn condition of the electrical bye to skid situation should be periodically corrected in order to adapt to the location of motor belt tensioning force; inspection speed button on the operation panel emphasized the frequency output is too low, should be appropriate to increase the output frequency; inspection Flat on the adequacy of the lubrication should come on the second class in order to ensure the flexibility of the various operating components; dial up and check whether the plane bearing cap and die, appropriate adjustments and cap height (note: set up a small knitting machine switch has two trips, on-line tube after release began to play a role so that equipment downtime, resulting in continuous operation there is the law of downtime occur, have the attention of new equipment more friction, but also start the difficult situation that may arise, which belong to the normal situation, band running at about one week later, it will gradually reduce this phenomenon).
Matters & Attention:
1, the boot device has been pre-determined stability, do not shake the job can be carried out so as not to affect the use and production of quality equipment.
2, come on in each class at least once, to ensure the functioning of parts there is enough flexibility in order to avoid transmission rate of fever or abnormal parts wear in order to reduce the use of equipment.
3, timely processing equipment on the broken wires and other objects, rotating parts to avoid being brought into machine equipment transfer will not happen or dislocation caused by dial-bit card cause spindle go die situation, seriously affecting the use of equipment and production quality problems .
4, timely replace abnormal parts, in order to ensure production quality.
5, regular fastening devices, such as, screw, nut, in order to guarantee the stability of not functioning in order to avoid abnormal sound as well as the use of equipment.
6, give the chain lubrication to prevent oil entering the frame-up of the friction disc, friction disc cause skidding aircraft affect the intake line of work.
7, proper control of inverter output frequency, so as not to affect the use of period equipment.
|
